This is what it gives every time I try to use OpenICE using windows 10 system. In either way I try to run the program the only thing I can see is this. Can you please help?

Hi,

I am facing a similar issue while using the Philips Effecia CM120 patient monitor. I've installed the OpenICE v 0.6.3 64x in Windows 10. I am trying to get an HL7 output on the OpenICE tool.

My setup is as follows: -

1. The patient monitor connected to the router using a cat5 cable.

2. The router connected to my laptop using WiFi.

3. IP address and port number assigned to my laptop is the same in the patient monitor and the tool "host".

4. Start the HL7 engine on OpenICE tool.

This is the whole procedure I've set up.

Can I get any help to get the HL& out of the patient monitor ysing OpenICE tool.

Thankyou.